Chrysler 1998 Voyager Service Manual page 47

NS
REMOVAL AND INSTALLATION (Continued)
Fig. 11 Hub/Bearing To Stub Axle Retaining Nut
Fig. 12 Wave Washer
CAUTION: Wheel bearing damage will result if after
loosening hub nut, vehicle is rolled on the ground
or the weight of the vehicle is allowed to be sup-
ported by the tires.
(5) With the vehicle's brakes applied to keep hub
from turning, loosen and remove the stub axle to
hub nut.
(6) Remove the 2 front disc brake caliper to steer-
ing knuckle attaching bolts (Fig. 13).
(7) Remove the disc brake caliper from the steer-
ing knuckle. Caliper is removed by first rotating top
of caliper away from steering knuckle and then
removing bottom of caliper out from under machined
abutment on steering knuckle (Fig. 14).
(8) Support disc brake caliper assembly by using a
wire hook and suspending it from the strut assembly
(Fig. 15). Do not allow the brake caliper assem-
bly to hang by the brake flex hose.
Fig. 13 Front Disc Brake Caliper Attaching Bolts
Fig. 14 Brake Caliper Mounting To Steering Knuckle
Fig. 15 Correctly Supported Disc Brake Caliper
SUSPENSION 2 - 15