Chrysler 1998 Voyager Service Manual page 486

8L - 8 LAMPS
REMOVAL AND INSTALLATION
CENTER HIGH MOUNTED STOP LAMP
(CHMSL) BULB . . . . . . . . . . . . . . . . . . . . . . . 12
CITYLIGHT LAMP BULB
FOG LAMP BULB . . . . . . . . . . . . . . . . . . . . . . . . 9
REMOVAL AND INSTALLATION
HEADLAMP BULB
REMOVAL
(1) Release hood latch and open hood.
(2) Remove headlamp module from vehicle.
(3) Remove rubber seal boot (Fig. 1).
(4) Disengage retaining spring clip from headlamp
(Fig. 2).
(5) Pivot spring clip from headlamp bulb removal
path.
(6) Pull headlamp bulb from back of headlamp
(Fig. 3).
Fig. 1 Rubber Boot Seal
INSTALLATION
CAUTION: Do not touch the glass of halogen bulbs
with fingers of other possibly oily surface. Reduced
bulb life will result.
(1) Insert headlamp bulb to headlamp.
(2) Pivot spring clip over headlamp bulb.
(3) Engage retaining spring clip to headlamp.
(4) Install rubber seal boot.
LAMP BULB SERVICE
page
. . . . . . . . . . . . . . . . . . 9
INDEX
FRONT TURN SIGNAL LAMP BULB . . . . . . . . . . 8
HEADLAMP BULB . . . . . . . . . . . . . . . . . . . . . . . 8
LICENSE PLATE LAMP BULB
SIDE REPEATER LAMP BULB . . . . . . . . . . . . . 10
TAIL LAMP BULB . . . . . . . . . . . . . . . . . . . . . . . 10
Fig. 2 Headlamp Bulb Spring Clip
Fig. 3 Headlamp Bulb
(5) Engage wire connector to headlamp bulb base.
(6) Install headlamp module into vehicle
(7) Verify headlamp alignment.
FRONT TURN SIGNAL LAMP BULB
REMOVAL
(1) Remove headlamp module from vehicle
NS/GS
page
. . . . . . . . . . . . . 12