Chrysler 1998 Voyager Service Manual page 331

NS
REMOVAL AND INSTALLATION (Continued)
REMOVAL
(1) Disconnect electrical connector from knock sen-
sor.
(2) Use a crow foot socket to remove the knock
sensor.
INSTALLATION
(1) Install knock sensor. Tighten knock sensor to
10 N·m (7 ft. lbs.) torque. Over or under tighten-
ing effects knock sensor performance, possibly
causing improper spark control.
(2) Attach electrical connector to knock sensor.
SPECIFICATIONS
IGNITION COIL
Coil Manufacture
Weastec (Aluminum Towers)
Diamond Electric (Brass Towers)
Coil Polarity
Primary Resistance at 21°C-27°C
(70°F-80°F)
0.45 TO 0.65 Ohms
0.45 TO 0.65 Ohms
IGNITION SYSTEM
Fig. 12 Knock Sensor
Secondary Resistance at 21°C-
27°C (70°F-80°F)
7,000 to 15,800 Ohms
7,000 to 15,800 Ohms
Coil Polarity
8D - 33