Chrysler 1998 Voyager Service Manual page 466

8L - 14 LAMPS
GENERAL INFORMATION
HEADLAMP DIMMER SWITCH . . . . . . . . . . . . . . 14
HEADLAMP MODULE . . . . . . . . . . . . . . . . . . . . 14
HEADLAMP SWITCH . . . . . . . . . . . . . . . . . . . . . 14
REMOVAL AND INSTALLATION
CENTER HIGH MOUNTED STOP LAMP
(CHMSL) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
FOG LAMP – TOWN and COUNTRY . . . . . . . . . 15
FOG LAMP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
GENERAL INFORMATION
HEADLAMP MODULE
Minor amounts of fogging may occur around the
edges of the headlamp lens when exposed to humid
conditions. This is considered normal. The fogging
will dissipate with increased ambient temperature or
headlamp usage.
HEADLAMP SWITCH
Service procedures for the headlamp switch can be
found in Group 8E, Instrument Panel and Gauges.
More information can be found in Group 8W, Wiring
Diagrams.
HEADLAMP DIMMER SWITCH
The headlamp dimmer switch is incorporated into
the multi-function (turn signal) switch. Proper proce-
dures can be found in Group 8J, Turn Signal and
Flashers. More information can be found in Group
8W, Wiring Diagrams.
REMOVAL AND INSTALLATION
HEADLAMP MODULE
REMOVAL
(1) Release hood latch and open hood.
(2) From inside engine compartment, remove nuts
holding headlamp module to radiator closure panel.
(3) Remove screw holding top of module to closure
panel.
(4) Remove headlamp module from radiator clo-
sure panel (Fig. 1).
(5) Disconnect wire connectors from back of head-
lamp module.
(6) Separate headlamp module from vehicle.
EXTERIOR LAMP SERVICE
INDEX
page
FRONT PARKING AND TURN SIGNAL LAMP –
TOWN and COUNTRY . . . . . . . . . . . . . . . . . . 15
FRONT SIDE MARKER LAMP TOWN and
COUNTRY . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
HEADLAMP MODULE . . . . . . . . . . . . . . . . . . . . 14
LICENSE PLATE LAMP . . . . . . . . . . . . . . . . . . . 16
TAIL, STOP, TURN SIGNAL AND BACK-UP
LAMP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
Fig. 1 Headlamp Module – Typical
INSTALLATION
(1) Place headlamp module in position on vehicle.
(2) Connect wire connectors into back of headlamp
module.
(3) Place headlamp module in position on radiator
closure panel.
(4) Install nuts to hold headlamp module to radia-
tor closure panel.
(5) Install screw to hold top of module to closure
panel.
(6) Verify headlamp operation and alignment.
FOG LAMP
REMOVAL
(1) Remove screws holding fog lamp to front
bumper fascia (Fig. 2).
(2) Remove fog lamp from fascia.
(3) Disconnect wire connector from body wire har-
ness.
(4) Remove fog lamp from vehicle.
NS
page