Chrysler 1998 Voyager Service Manual page 197

NS/GS
REMOVAL AND INSTALLATION (Continued)
Fig. 5 Console Retaining Screws
(7) Remove the four (4) retaining screws (Fig. 5).
(8) Pull the parking brake lever to the "up" posi-
tion and lift the console (Fig. 5).
(9) Tilt the base of the gearshift boot and carefully
push through the opening in the console while lifting.
(10) Remove the three (3) nuts at the base of the
parking brake assembly.
(11) Release the parking brake assembly and lift
assembly off of the parking brake/gearshift lever
bracket.
(12) Unhook the loop on the end of the parking
brake from the equalizer bar on the parking brake/
gearshift lever bracket.
(13) Compress the parking brake cable retainer by
sliding a 14 mm box wrench over the cable retainer
and compress the three (3) retaining fingers.
(14) Remove the three (3) screws from the parking
brake grommet on the floor pan of the passenger
compartment.
(15) Lift the parking brake /gearshift lever bracket
and slide the parking brake cable out.
(16) Pull the cable through the floor pan from
inside the vehicle.
INSTALL
(1) Pass park brake cable assembly through hole
in floor pan from the inside of the vehicle.
(2) Pass cable strand button through the hole in
the pedal assembly bracket.
(3) Install parking brake cable to the brake/gear-
shift lever bracket by lifting the bracket and sliding
the cable in.
(4) Install the three (3) screws to the parking
brake grommet on the floor pan of the passenger
compartment.
(5) Compress the parking brake cable retainer by
sliding a 14 mm box wrench over the cable retainer
and compress the three (3) retaining fingers.
(6) Hook the loop on the end of the parking brake
to the equalizer bar on the parking brake/gearshift
lever bracket.
(7) Attach the parking brake assembly and place
assembly on the parking
bracket.
(8) Install the three (3) nuts at the base of the
parking brake assembly.
(9) Pull the parking brake lever to the "up" posi-
tion.
(10) Place the console over the parking brake/gear-
shift lever and tilt the base of the gearshift boot and
carefully pull it through the opening in the console.
(11) Install the four (4) retaining screws (Fig. 5).
(12) Carefully press the three (3) clips at the base
of the gearshift boot into the slots on the gearshift
console.
(13) Raise the vehicle.
(14) install the two (2) retaining nuts and (2)
retaining bolts to the bottom of the parking brake/
gearshift lever bracket.
(15) Install the front park cable housing retainer
to the body outrigger bracket (Fig. 3). Cable is
installed by sliding a 14 mm box wrench over cable
retainer and compressing the three retaining fingers.
Alternate method is to use an aircraft type hose
clamp and screwdriver.
(16) Install the intermediate and left rear park
brake cable to the park brake cable equalizer (Fig. 2).
(17) Lower the vehicle.
BRAKES 5 - 3
brake/gearshift lever