Chrysler 1998 Voyager Service Manual page 490

8L - 12 LAMPS
REMOVAL AND INSTALLATION (Continued)
LICENSE PLATE LAMP BULB
REMOVAL
(1) Press one retaining tab on license plate lamp
housing toward center of lens (Fig. 13).
(2) Separate lamp lens from lamp housing.
(3) Pull lamp bulb from socket.
Fig. 13 License Plate Lamp Lens
INSTALLATION
(1) Align license plate lamp bulb to lamp socket.
(2) Push bulb into socket.
(3) Position lamp lens to lamp housing.
(4) Snap lamp lens onto tabs on lamp housing.
CENTER HIGH MOUNTED STOP LAMP (CHMSL)
BULB
REMOVAL
(1) Release liftgate latch and open liftgate.
(2) Disengage clips holding CHMSL cover to lift-
gate trim panel (Fig. 14).
(3) Separate CHMSL cover from liftgate trim
panel.
(4) Depress plastic tab holding bulb holder to lamp
housing (Fig. 15).
(5) Separate bulb holder from lamp housing.
(6) Pull bulb or if equipped bulbs from lamp socket
(Fig. 16).
INSTALLATION
(1) Align bulb to bulb holder socket.
(2) Push bulb into bulb holder socket.
(3) Position bulb holder to CHMSL housing.
(4) Snap bulb holder into CHMSL housing.
(5) Position CHMSL cover to liftgate trim panel.
(6) Engage clips to hold CHMSL cover to liftgate
trim panel.
Fig. 14 CHMSL Cover
Fig. 15 CHMSL Bulb Holder
Fig. 16 CHMSL Bulb
NS/GS