Mounting Cabinet 1 And Cabinet 2 - Vodavi XTS-IP Installation Manual

3-6
Chapter 3 - System Installation
The Cabinet is mounted with four #10 or larger, 1 ½ inch or longer screws.
1. Drill pilot holes in the locations marked, insert the screws and tighten, leaving about ½
inch exposed.
2. Mount the Cabinet on the screws and tighten the screws securely.

Mounting Cabinet 1 and Cabinet 2

The optional Cabinets include a metal housing designed for wall mount installation. Cabinet
1 is mounted above Cabinet 0 and Cabinet 2 is mounted above Cabinet 1. Use the same
procedure for mounting Cabinets 4 and Cabinet 5.
1. Before mounting the optional Cabinets, remove the Interconnection Cover on the top
right side of Cabinet 0 and Cabinet 1 and on the bottom of Cabinet 1 and Cabinet 2.
2. Mount the optional Cabinet on the screws and tighten the screws securely.
3. Mount the four side brackets between the Cabinets.
4. Interconnection is achieved via a amphenol-type connector. No cable is used to connect
the Cabinets together. Refer to
XTS-IP - Installation Manual
Figure 3-2: Mounting XTS-IP Cabinet
Figure 3-3.
KSU Installation
December 2005