Wall Mounting The Digital Key Telephone - Vodavi XTS-IP Installation Manual

3-72
Chapter 3 - System Installation

Wall Mounting the Digital Key Telephone

To wall mount the 8-button or 30-button digital key telephone, use the appropriate wall
mount bracket and a standard-type jack designed for 630-type wall hanging applications.
1. Remove the handset from the cradle and locate the plastic retainer in the bottom of the
hookswitch well area.
2. Slowly push the plastic retainer upward until it is free.
3. Locate the tab on the plastic retainer so that it is oriented towards the top of the keyset.
4. Slide the plastic retainer into its channel. Part of the retainer remains above its holder to
secure the handset during use in a wall mount configuration.
5. Turn the telephone over and unplug the line cord.
6. Run the line cord through the rectangular hole of the wall mount and plug one end into
the connector on the base of the telephone.
7. Align the prongs on the top and bottom of the wall mount bracket so that they can
engage with the slots in the bottom of the telephone base. Insert the top prongs first.
8. Press the wall mount bracket slowly upward until the bottom prongs slide into the
bottom slots and snap into place.
9. Plug the line cord from the KTU into the connector on the 630-A jack (refer to
Electronic Key Telephone Wall Mounting
10. Match the two keyhole slots on the wall mount bracket with the lugs on the 630-A jack,
then slide the telephone into place.
11. Place the handset into its cradle.
30-Button KTU Base
30-Button Wall Mount
XTS-IP - Installation Manual
Wall Mounting the Digital Key Telephone
for an illustration of a 630-A jack).
8-Button KTU Base
Slots
8-Button Wall Mount
Prongs
Figure 3-45:
December 2005