Vodavi XTS-IP Installation Manual page 149

Maintenance Access
Event Trace Mode
The "t" command enables and disables the Trace mode in the XTS-IP System. While the trace
mode is enabled, events for the trace selected are displayed in an event record on the monitor,
printer, or PC connected to the XTS-IP System.
To view the current status of the trace mode:
1. Type t at the mon> prompt.
2. Then press <Enter> to display the following commands:
To enable an Event Trace:
1. Type: t<space>(followed by the letter that indicates the kind of specific trace needed)
B = Board event trace (traces events associated with PCBs)
C = CO Line (LCOB) States (traces events associated with CO Line activity)
D = Device Command (traces commands to peripheral devices)
E = Error Messages (traces error messages)
H = Hardware States (traces events associated with hardware states)
I = CTI (traces from and to devices)
K = LCD (traces commands to devices)
L = LED (traces commands to devices)
M = Miscellaneous State event trace
P = Pulse Coded Modulation (PCM) traces events associated with voice communications
Q = Queue (QUE) Events (traces queuing events, e.g.: DTMF receiver, UCD, LCR, etc.)
S = Station (STA) States (traces events associated with Station activity)
2. Type the specific board, CO line, or Station number of the trace desired,
-or-
Type all if all boards, CO line, or Station events are desired.
XTS-IP - Installation Manual
Figure 4-7: Remote Monitor - Trace Mode Status
Chapter 4 - Maintenance and Troubleshooting
4-23
December 2005