Event Trace Buffer Commands - Vodavi XTS-IP Installation Manual

Maintenance Access
Event Trace Buffer
The Event Trace Buffer is used to store and dump event traces (up to 30) that occur just prior
to an XTS-IP System soft or hard restart. These can be reviewed by authorized personnel to aid
in system troubleshooting. The basic format for each command is shown in the following table:
Command
t<space><Enter>
t<space>0<Enter>
t<space>1<Enter>
t<space>2<Enter>
t<space>3<Enter>
d<space>E<Enter>
d<space>b<Enter>
r<space>SXXX<Enter> Permits a specific station to be reset.
r<space>CXX<Enter>
XTS-IP - Installation Manual
Table 4-16: Event Trace Buffer Commands
Displays the current status of the Event trace buffer.
Turns the Trace buffer OFF.
Turns the Trace buffer ON to record events prior to a soft
system reset.
Turns the Trace buffer ON to record events prior to a hard
system restart.
Turns the Trace buffer ON to record events prior to either a
soft reset or a hard system restart.
Dumps Trace Events stored from last system reset (soft or
hard).
Permits maintenance personnel to determine the busy
status of all the busy keysets and CO Lines in the system,
including the T1 lines.
Permits a specific CO Line to be reset.
Press <Ctrl + C> to abort the Data Dump and return to the maint> prompt.
Chapter 4 - Maintenance and Troubleshooting
Function
4-19
December 2005