Wall Mounting The Electronic Key Telephone; Electronic Key Telephone Wall Mounting - Vodavi XTS-IP Installation Manual

Wall Mounting the Electronic Key Telephone

Wall Mounting the Electronic Key Telephone
All connections to the Electronic Key Telephone are fully modular. To wall mount the
Electronic Key Telephone, it is necessary to have one Wall Mount Kit and one standard-type
jack assembly designed for normal wall hanging applications.
1. Unplug the line cord from the phone. This line cord is not required and should be
retained as a maintenance replacement item.
2. Lift the plastic number retainer upward and expose the screw underneath. Remove the
screw and the handset tab. Replace it with the handset tab from the Wall Mount Kit.
3. Be careful to position the tab so that the protrusion faces the hookswitch. This allows the
handset to remain secure when the telephone is on the wall. Replace the screw and snap
the number retainer into place.
4. Substitute the short modular cord from the Wall Mount Assembly into the modular
connector vacated by the line cord.
5. Align the wall mount base plate with holes on the bottom of the phone. Snap in place.
6. Match the two key hole slots on the base plate with the lugs on the 630-A type jack. Align
the modular connector and slide telephone into place. Refer to
XTS-IP - Installation Manual
Figure 3-45: Electronic Key Telephone Wall Mounting
Chapter 3 - System Installation
630-A Jack
3-73
Figure 3-45.
December 2005