Vodavi XTS-IP Installation Manual page 29

System Components
Number of
Item
Time Slots
PFTU ---
PMU ---
PMU ---
PRIB up to 24
PSU ---
RAU ---
RGU3 ---
SIU ---
SLIBC 12
SLIBE 12
T1IB up to 24
VMIB 8
VMIB 12
VOIP up to 8
VOIP up to 8
VOIP up to 8
VOIP up to 8
Module --
VOIP24 up to 24
Module --
The first range, for entries that show two ranges of slot positions, applies to Cabinet 0. The second range of slot positions
applies to slots in other cabinets where the card can be used.
EXAMPLE -- The T1IB can be used in slot 1-7 of Cabinet 0 and in slots 0-7 in Cabinets 1 & 2.
XTS-IP - Installation Manual
Table 2-2: System Card Description
Slot
Cabinets
Position
---
MPB1
MPB2/MPBE
1-7 or 0-7 0, 1, & 2
PSU
RAU 0
---
MISB
1-7 or 0-7 0, 1, 2, & 3 Single Line Interface Board w/ Caller ID
1-8 or 0-8 All
1-7 or 0-7 0, 1, & 2
1-7 or 0-7 0, 1, 2, & 3 Voice Mail Interface Board - Flash-based
1-7 or 0-7 0, 1, 2, & 3 Voice Mail Interface Board - Hard Drive-based
1-7 or 0-7 0, 1, 2, & 3 VoIP Card w/one VoIP Module
1-7 or 0-7 0, 1, 2, & 3 VoIP Card w/two VoIP Modules
1-7 or 0-7 0, 1, 2, & 3 VoIP Card w/three VoIP Modules
1-7 or 0-7 0, 1, 2, & 3 VoIP Card w/four VoIP Modules
VOIP
1-7 or 0-7 0, 1, 2, & 3 VoIP24 Base Card (12 port)
VOIP24
Chapter 2 - System Specifications
Description
Power Failure Transfer Unit
Program Module Unit, 4 MB ROM
Program Module Unit, 8 MB ROM
Primary Rate Interface Board
Power Supply Unit, 350W
Relay Alarm Unit
Ring Generator Unit (25Hz): Sine Wave, Internal
Serial Interface Unit
Single Line Interface Board
T1 Interface Board
VoIP module (only for upgrade)
Daughterboard for VoIP24 Card
2-5
December 2005