3-62
Chapter 3 - System Installation
Hard Drive-Based Voice Mail System
Installing the Hard Drive-Based Voice Mail Card
The Hard Drive-based Voice Mail Card consists of a printed circuit board. After powering down
the KSU, install the voice mail card into slots 1-7 of cabinet 0, or slots 0-7 of cabinets 1-3.
Equipment Handling -- Take every precaution to prevent static charges and physical strain
from being applied to the Hard Drive-based Voice Mail card. When connecting this device,
power off the KSU and brace the ports as the connector is being inserted.
Before powering up the KSU, make any cable connections to the voice mail card as
referenced below.
XTS-IP - Installation Manual
RS-232
LAN
(Programming)
(File Transfer)
Figure 3-34: Hard Drive-Based Voice Mail Card
Hard Drive-Based Voice Mail System
VGA Monitor
USB Ports 1 & 2
(Diagnostics)
(other PC Devices)
December 2005