Vodavi XTS-IP Installation Manual page 150

4-24
Chapter 4 - Maintenance and Troubleshooting
3. Then press <Enter> to enable the trace.
To disable or turn off a particular Trace Mode:
Do not enter a specific board, CO Line, or Station Number
(i.e., t<space>s<Enter> to disable station event trace).
To display an Event Trace on screen:
Type x at the mon> prompt to exit the MONitor mode. Once you exit the event, the trace
will begin as shown in
Modify Memory Command
The modify memory command is for engineering use only.
XTS-IP - Installation Manual
Figure 4-8.
Unless instructed by personnel at
mode enabled for extended periods of time. The system dumps the requested
event(s) trace which may use up paper or fill memory buffers on the collecting
device. It is recommended that the trace events be disabled (turned off) for all
event(s) traces before leaving the system site.
Use of this command can alter or damage the
which can result in system malfunction.
If this occurs it is necessary to power the system down and re-initialize the database,
then completely reprogram the customer programming data.
, do not leave the trace
VODAVI Technical Support
XTS-IP
System's operating database
Maintenance Access
December 2005