Headset Installation; Caller Id Interface Unit Installation; Selecting The Cable - Vodavi XTS-IP Installation Manual

3-74
Chapter 3 - System Installation

Headset Installation

Digital Key Telephones used with the XTS-IP have been designed to operate with
industry-standard electret-mic-compatible modular headset adapters and operator
headsets. The Executive 8-Button Speakerphone (P/N 3012) and the Executive 30-Button
Speakerphone (P/N 3015 & 3017) models have a 2.5 mm jack located on the left side of the
keyset.
To modify a Digital Key Telephone to support an external headset:
1. Plug the headset adapter cord into the vacant handset jack on the Key Telephone base.
2. Plug the telephone handset cord into the headset adapter box where indicated by the
headset manufacturer's instructions.
-or-
Plug the headset cord into the 2.5 mm jack.
The Headset Operation must be enabled (refer to Handset/Headset Mode in the Programming
and Operations Manual). The station then has the capability to enable/disable headset mode
by dialing a code. When Headset mode is active at the station, the ON/OFF button controls
the on-hook or off-hook status. Also, features such as on-hook dialing and handsfree
speakerphone operation become inoperable.

Caller ID Interface Unit Installation

The Caller Identification Interface Unit receives the data from the telephone company and
sends the data, in ASCII RS-232C format to a printer, telephone, computer or DTE (Data
Terminal Equipment) device.

Selecting the Cable

1. Select the correct cable for the MPB and SIU.
To connect a 1480-00 caller ID box to the SMC1 connector of the MPB or to the SIU,
use cable P/N 9081-01.
To connect a 7480-00 caller ID box to the SMC1 connector of the MPB or to the SIU,
use the flat ribbon cable supplied and the 7481-10 adapter kit.
2. Connect one end of the cable on the desired KSU I/O port (3, 4, or 5).
XTS-IP - Installation Manual
Headset Installation
December 2005