How to enable the break signal and STOP+A command
2.3.8 LAN expansion note
When LAN ports have seen added with PCI cards, and each LAN port given its own MAC address, these should
be enabled from the ok prompt, as follows:
1
Use the print-fw-options command to check the current setting values. If the no-break shown
below is not displayed, the break signal and STOP+A command are already enabled.
ok print-fw-options
fw-options = no-break
2
Use the clear-fw-options command to cancel the no-break setting.
ok clear-fw-options no-break
fw-options =
3
Use the print-fw-options command to make sure that nothing is set.
ok print-fw-options
fw-options =
ok setenv local-mac-address? true
2.3 Preparations for Use
19