Os Settings - Fujitsu Primepower200 User Manual

CHAPTER 11 Internal I/O Units

11.6.3 OS settings

Before using a DLT tape drive, the /kernel/drv/st.conf file must be modified, as follows:
1
Copy the original st.conf file:
# cp /kernel/drv/st.conf /kernel/drv/st.conf.old
2
Add the following lines to the /kernel/drv/st.conf file:
IMPORTANT
If another tape-config-list has already been defined, use a "," as a separator and add the new lines
as shown in the following example.
3
Shut the system down:
# shutdown -y i0
4
Then reboot the system, using the -r flag:
ok boot -r
218
tape-config-list =
"QUANTUM DLT7000","QUANTUM DLT7000","DLT7k-data";
DLT7k-data = 1,0x36,0,0xD639,4,0x82,0x83,0x84,0x85,2;
Tape-config-list =
"EXABYTE EXB-8505", "Exabyte 8mm EXB-8505", "EXBT-8SC",
"QUANTUM DLT7000","QUANTUM DLT7000","DLT7k-data";
EXBT-8SC = 1,0x35,0,0xce39,2,0x15,0x8c,1;
DLT7k-data = 1,0x36,0,0xD639,4,0x82,0x83,0x84,0x85,2;