Table 11.13 Dlt Cleaning Cartridge - Fujitsu Primepower200 User Manual

Cleaning cartridge
Cleaning the tape heads
1
Make sure that Operate Handle LED (green) is lit before raising the cartridge handle.
2
Insert the cleaning cartridge.
3
Push the cleaning cartridge in.
4
Lower the cartridge handle.
5
The Operate Handle LED goes out and the Tape in Use LED starts to blink, and cleaning is
automatically executed.
6
When cleaning is completed, the Operate Handle LED lights up.
7
Lift up the cartridge handle.
8
After lifting up the cartridge handle wait at least two seconds before ejecting the data cartridge.
9
Lower the cartridge handle.
Replacing the cleaning cartridge
Replace the cleaning cartridge in the following instances:
 When it has been used 20 times (may vary if also used with other devices)
 When the Use Cleaning Tape LED does not go out even after the cleaning cartridge has been
used.
Table 11.13 DLT Cleaning Cartridge
Part Name
DLT Cleaning Tape III
Supplier Qty.
Maxell 1 tape
11.6 DLT Tape Drive
225