Scsi Id - Fujitsu Primepower200 User Manual

CHAPTER 11 Internal I/O Units
(4) Eject Button
(5) Data Cartridge Slot

11.5.2 SCSI ID

Set the SCSI ID of the 8mm tape drive to "5" if it is the 1st drive in the PRIMEPOWER or the Expansion File Unit
Type-2. Set the SCSI ID to "3" if it is the 2nd drive.
11.5.3 OS settings
Before using a 8mm tape drive, the /kernel/drv/st.conf file must be modified, as follows:
1
Copy as original st.conf file:
# cp /kernel/drv/st.conf /kernel/drv/st.conf.old
2
Add the following lines to the /kernetl/drv/st.conf file:
208
Table 11.7
Warning Access Ready
LED LED LED
Lit Lit Lit
Fast Blink (any) Dark
Dark (any) Dark
Dark (any)
Lit
Dark (any) Slow Blink
Dark (any) Fast Blink
Lit Lit Lit
Slow Blink (any) Dark
Fast Blink (any) Fast Blink
Dark (any) Slow Blink
Press the Eject button to remove the data cartridge. Before removing a data cartridge, make sure
that the Tape LED is out.
If the 8mm Tape software has disabled removal of a data cartridge, the cartridge cannot be removed
by pressing the Eject button.
Never insert your fingers or other foreign objects in the data
CAUTION
cartridge slot, as this may damage the unit or cause data to be lost.
8mm Tape Unit LED States
Tape Drive Status
Performing start-up diagnostics
Diagnostic error has occurred
Data cartridge is not loaded
Data cartridge is loaded and idle
Loading or running tape (normal speed)
Loading/unloading or running tape (high speed)
SCSI bus is being reset
Drive has malfunctioned
Tape heads require cleaning
Tape heads being cleaned