CHAPTER 5 PRIMEPOWER400 Rackmount (4U) Server
5.2.3 Rear side
The names and functions of parts on the rear of the PRIMEPOWER400 Rackmount (4U) Server are as follows.
(1) AC power input
(2) PCI slots
(3) RCI port (label : RCI)
(4) UPS port (label : UPS)
(5) Power control port (label : PC)
(6) 100Base-TX ports (label : LAN)
(7) Keyboard port (label : KB)
(8), (9) Serial port (label : SERIAL A/B)
72
(4) UPS port
(5) Power control port
(7) Keyboard port
Figure 5.4
Connect the power cable to this point.
PCI slots conform to the PCI local bus specifications (Rev. 2.1).
64-bit bus, 33MHz (5.0 V) and 33/66MHz (3.3V) are supported.
Both short cards (17.46 cm, 6.87 in.) and long cards (31.19 cm, 12.3 in.) are supported.
RJ11 connector for connecting the RCI cable and terminator (provided with the server unit)
Dsub-9 pin for connecting the signal cable of an uninterruptible power supply
8-pin DIN for power control
RJ45 connector automatically recognizes 10Mbps/100Mbps
8-pin DIN port for connecting a keyboard cable
Dsub-25 pin ports for connecting a console terminal when performing maintenance on the server
unit using the RS-232C interface
(8) Serial port B
(9) Serial port A
(3) RCI port
Rear of PRIMEPOWER400 Rackmount (4U) Server
(2) PCI slots
(1) AC power input
(6) 100Base-TX port