Lcd Initial Diagnostics Sequence - Fujitsu Primepower200 User Manual

13.3 LCD Initial Diagnostics Sequence

LCD panel sequence
Figure 13.1 shows the major messages that are displayed on the LCD panel during the
PRIMEPOWER start-up process. These messages will appear in the order indicated.
SCF:initial
I/O Power on
diagnostic alarm
POST:Executing#
test_name
OBP stop
OBP:Initializing
Just a moment
e.g. : Probing Memory
Probing CPU
Probing PCI
Scrubbing Memory
Booting
Operating System
Figure 13.1
If power-on processing does not start after the power switch is turned on, check that the power cable
is properly connected to the AC power inlet, and that the MODE switch is set to SECURE.
13.3 LCD Initial Diagnostics Sequence
POST:ERR######## ########: error code
Component
diagnostic stop
POST:ERROR STOP
OBP:STOP
check error logs
Initial Diagnostics Sequence
e.g. : RED state trap
Reset Switch
233