Figure 10.4 Disk Drive + Tape Drive Configuration Of Expansion File Unit Type-2; Hot-Swapping Redundant Components - Fujitsu Primepower200 User Manual

10.5 Hot-swapping Redundant Components

This section describes hot-swapping of redundant components.
10.5.1 Power supply units
CAUTION
Base SCSI Unit
#1 #2 #4
#3
Figure 10.3 Full Disk Drive Configuration of Expansion File Unit Type-2
Base SCSI Unit
#1 #2 #4
#3
Figure 10.4 Disk Drive + Tape Drive Configuration of Expansion File Unit Type-2
Unit Damage
The unit may be damaged if hot-swapping of power supply units is not
performed correctly. Contact the service engineer if a power supply unit must be
hot-swapped.
10.5 Hot-swapping Redundant Components
ACTIVE LED (Green)
FAULT LED (Amber)
#5 #1
ACTIVE LED (Green)
FAULT LED (Amber)
#5
File Unit Expansion Kit
#2 #4 #5
#3
Expansion Tape Unit
#2
#1
183