Mitel 5340 User Reference Manual page 47

Mitel IP Phone User Reference Guide Release 4.1
Logout from the 5224/5324 phone
To log out of a phone, follow these steps when your phone has no calls
connected. At the start, the display should display the following:
1. Press the MENU softkey.
2. Press the LOGOUT softkey
The LCD displays a confirmation message.
3. Press the YES softkey to proceed. The LCD will display the message
"Logout successful", confirming that you are logged out of the phone and the
system. Incoming calls will be forwarded to Call Coverage. The display will
return to a logged out/unassigned idle state
.
NOTE: If your phone has been locked you cannot log out of the phone. The
LOGOUT softkey will not be displayed on your phone. Contact your system
administrator for assistance.
You cannot log in or out, or activate a phone, while the phone is on an active
call.
You can press the
After you have logged out of the phone, callers to your extension will be
directed to your call coverage target. If no call coverage target is set, the
phone will ring until the caller hangs up.
If the primary member of a Monitor Group logs out of the phone, calls to the
Monitor Group will still ring any secondary phones and will redirect to the
primary member's call coverage target after the configured number of rings.
For more information about Monitor Groups, see "Monitor groups on the
5224/5324 phone" on page 46.
If a logged out phone has twinning configured, the twinning target phone will
ring and the call wil be redirected to the logged-out phone's call coverage
target after the configured number of rings.
Extension: 314
REDIAL CALLS MENU
MENU
LOGOUT DIR QUIT
Confirm Logout
YES
Logout Successful
Logged Out
ACTIVATE
key instead of the QUIT softkey.
NO
45