ADJUSTING THE REAR BRAKE/
ADJUSTING THE PARKING BRAKE
a
2
1
2. Adjust:
• rear brake pedal height
a. Loosen the locknut
b. Turn the adjusting bolt
pedal height is within the specified limits.
c. Tighten the locknut.
NOTE:
NOTE:
When adjusting the brake pedal height make
sure the locknut-to-adjusting bolt clearance
does not exceed 2.2 ~ 3.2 mm (0.09 ~ 0.13 in).
WARNING
After this adjustment is performed, lift the
front and rear wheels off the ground by
placing a block under the engine, and spin
the rear wheels to ensure there is no brake
drag. If any brake drag is noticed, perform
the above steps again.
ADJUSTING THE PARKING BRAKE
1. Check:
• parking brake cable end length
Out of specification → Adjust.
Parking brake cable end length
64 ~ 68 mm (2.52 ~ 2.68 in)
3-27
CHK
ADJ
.
until the brake