Yamaha YFM250RX 2008 Service Manual page 165

CLUTCH
11.Adjust:
• Push lever position
a. Loosen the locknut
b. Turn the adjusting screw
the marks are aligned.
c. Hold the adjusting screw to prevent it from
moving and then tighten the locknut to
specification.
CAUTION:
Do not overtighten the locknut since this
will remove the free play between both
push rods.
12.Check:
• Clutch cable free play
Refer to "ADJUSTING THE CLUTCH
CABLE FREE PLAY" in chapter 3.
Clutch lever free play
5 ~ 10 mm (0.20 ~ 0.39 in)
13.Install:
• Spacer
• Dowel pin
• Crankcase cover gasket
14.Install:
• Right crankcase cover
15.Install:
• Crankcase cover bolts M6 × 50 mm
• Copper washers to
• Crankcase cover bolts M6 × 40 mm
• Crankcase cover bolts M6 × 25 mm
• Oil filter element cover bolt M6 × 70 mm
16.Tighten:
• Crankcase cover bolts
• Oil filter element cover bolt
NOTE: NOTE:
Tighten the bolts in stages, using a crisscross
pattern.
Crankcase cover bolt
10 Nm (1.0 m•kg, 7.4 ft•lb)
Oil filter element cover bolt
10 Nm (1.0 m•kg, 7.4 ft•lb)
4-49
ENG
.
in or out until
8 Nm (0.8 m•kg, 5.9 ft•lb)
,
,
~
~
~