Installing The Front Brake Master Cylinder - Yamaha YFM250RX 2008 Service Manual

FRONT AND REAR BRAKES
2. Tighten:
• nut
Nut
EBS00418
INSTALLING THE FRONT BRAKE MASTER
CYLINDER
1. Install:
• brake master cylinder
Brake master cylinder holder bolt
NOTE: NOTE:
• The "UP" mark on the brake master cylinder
bracket should face up.
• Install the brake master cylinder so that the
gaps between the brake master cylinder and
the brake master cylinder bracket are equal.
2. Install:
• copper washers
• brake hose
• union bolt
Union bolt
NOTE: NOTE:
• Tighten the union bolt while holding the brake
hose as shown.
• Turn the handlebar to the left and to the right
to check that the brake hose does not touch
other parts (throttle cable, wire harness,
leads, etc.). Correct if necessary.
WARNING
Proper brake hose routing is essential to
insure safe machine operation. Refer to
"CABLE ROUTING" in chapter 2.
6-26
CHAS
17 Nm (1.7 m•kg, 13 ft•lb)
7 Nm (0.7 m•kg, 5.1 ft•lb)
27 Nm (2.7 m•kg, 20 ft•lb)