Dynamic Damper Replacement - Honda EP3 Service Manual

Driveline/Axle
9 .
Driveshafts Disassembly (cont'dl
8. Remove the stop ring trom the driveshaft.
Wrap the splines on the driveshaft with vinyl tape
(A) to prevent damage to the boot.
Remove the outboard boot. Be careful not to
damage the boot.
Remove the vinyl tape.
1 0 .
1 1 .
16-8
7 .
Dynamic Damper Replacement
1 . R e m o v e t h e i n b o a r d j o i n t ( s e e p a g e 1 6 - 5 ) .
2, Remove the dynamic damper bands. Be careful not
to damage the dynamic damper (see page 16-5).
. l f t h e b o o l b a n d i s a w e l d e d t y p e . c u t t h e b o o t
b a n d .
. l f t h e b o o t b a n d i s a d o u b l e l o o p t y p e , l i f t u p t h e
band bend, and push it into the clip.
. lfthe boot band is a low profile type, pinch the
b o o t b a n d u s i n g a c o m m e r c i a l l y a v a i l a b l e b o o t
band pincers.
3. Wrap the splines on the driveshaft with vinyl tape
(A)to prevent damage to the dynamic damper.
Remove the dynamic damper. Be careful not to
d a m a g e t h e d y n a m i c d a m p e r .
Adjust the position of the new dynamic damper to
the figure below.
Left driveshaft {Directionall: 296 300mm
( 1 1 . 6 - 1 1 . 8 i n . )
Right driveshaft (Directionall: 301 305 mm
( 1 1 . 9 - 1 2 . 0 i n . l
5 .
6 . I n s t a l l t h e d y n a m i c d a m p e r b a n d ( s e e s t e p I o n
p a g e 1 6 ' 1 2 ) .
I n s t a l l t h e i n b o a r d j o i n t ( s e e p a g e 1 6 - 1 1 ) .