How To Clear Eps Dtcs; Honda Pgm Tesler Method - Honda EP3 Service Manual

EPS Components
General Troubleshooting Information (cont'dl
5. The blinking frequency indicates the DTC. DTCS are
indicated by a series of long and short blinks. One
l o n g b l i n k e q u a l s 1 0 s h o r t b l i n k s . A d d t h e l o n g a n d
short blinks together to determine the DTC. After
determining the DTC, refer to the DTC
Troubleshooting Index.
The system will not indicate the DTC unless these
conditions are met:
. Set the front wheels in the straight ahead driving
position.
. The ignition switch is turned ON (ll).
. The engine is stopped.
. The SCS circuit is shorted to body ground before
the ignition switch is turned ON (ll).
Example of DTC 23
Long blinks Short blinks
(two times) (three timesl
6 .
7 .
Turn the ignition switch OFF.
Disconnect the Honda PGM Tester from the DLC.
17-20
How to Clear EPS DTCs
Honda PGM Tesler Method:
1. With the ignition switch OFF, connect the Honda
PGM Tester (A) to the 16P data link connector (DLC)
( B ) l o c a t e d u n d e r t h e d a s h o n t h e d r i v e r ' s s i d e o f
the vehicle.
Turn the ignition switch ON (ll), and clear the
DTC{s) by following the screen prompts on the
PGM Tester.
NOTE: See the Honda PGM Tester user's manual
for specific instructions.