Honda EP3 Service Manual page 712

t 5 .
Glue the side rubber dams (A) and lower rubber
dam (B) with adhesive tape (NITTO 501M, or
equivalent). Glue the fasteners (C)with adhesive
tape (3M 4215, or equivalent) to the inside face of
t h e w i n d s h i e l d { D ) a s s h o w n :
. Be sure the rubber dams and fasteners line uD
w i t h t h e a l i g n m e n t m a r k s ( E ) .
. Be careful not to touch the windshield where
a d h e s i v e w i l l b e a o o l i e d .
t 3 .
1 4 . G l u e t h e m o l d i n g ( A ) w i t h a d h e s i v e t a p e { B )
( 3 M 4 2 1 2 , o r e q u i v a l e n t ) t o t h e u p p e r e d g e o f t h e
w i n d s h i e l d ( C ) ;
. B e s u r e t h e a l i g n m e n t m a r k ( D ) o f t h e m o l d i n g
l i n e s u p w i t h t h e a l i g n m e n t m a r k ( E ) o f t h e
w i n d s h i e l d .
. Be careful not to touch the windshield where
a d h e s i v e w i l l b e a p p l i e d .
Install the fasteners (A), retalners (B, C), and clips
(D) to lhe body.
Fastener Locations
A > : F a s t e n e r . 2 B > : R e t a i n e r , 2
q\
C > : R e t a i n e r , 6 O > : C l i p , 2
(cont'd)
20-21