Special Tools Required
. Boot band tool, KD-3191 or equivalent, commercially
a v a i l a b l e
. Boot band pincers, Kent-Moore J-359'10 or equivalent,
commerclally available
. Boot band pincers,commercially available
NOTE: Refer to the Exploded View as needed during
this procedure.
lnboard Joint Side:
1. Wrap the splines with vinyl tape (A) to prevent
damage to the inboard boot.
Install the inboard boot onto the driveshaft, then
remove the vinyl tape, Be careful not to damage
inboard boot.
I n e
4 .
5
3. Installthe spider (A) onto the driveshaft by aligning
the marks (B) on the spider and the end of the
driveshaft.
Fit the circlip (C) into the driveshaft groove. Always
rotate the circlip in its groove to make sure it is fully
seated.
Fit the rollers (A) onto the spider {B) with their high
shoulders facing outward, and note these items:
' Reinstallthe rollers in their original positions on
the spider by aligning the marks (C).
. Hold the driveshaft pointed up to prevent the
rollers from falling off.
(cont'd)
@\
(u
1 6 - 1 1