Honda EP3 Service Manual page 588

12. lnstallthe EPS wire harness bracket (A) on the
gearbox housing, and connect the 6P connector (B)
propefly.
9.8 N.m
{1.0 kgt m,7.2 lbt.ftl
1 3 . I n s t a l l t h e h e a t s h i e l d ( A ) .
,.!,..
' ' 6 f
1 4 .
1 5 .
Center the steering rack within its stroke.
Wipe off any grease contamination from lhe ball
joint tapered section and threads. Then reconnect
the tie-rod ends 1A)to the damper steering arms.
lnstall the ball joint nut (B) and tighten them.
Install the new cotter pins (C), and bend them as
shown.
(cont'd)
B
10 x 1.25 mm
i€ N.m
{4.4 kgf.m.
32 tbt.ftl
t o .
, -', ''l
: 1 )
17-65