Honda EP3 Service Manual page 175

Engine Block
Crankshaft Installation (cont'd)
Put the lower block on lhe cylinder block.
Tighten the bearing cap bolts in sequence to
29 N.m (3.0 kgf m, 22 lbf.ft).
Tighten the bearing cap bolts an additional 56".
Tighten the I mm bolts in sequence to 22 N.m 12.2
kgf m, 16 lbf.ft).
'17
.
1 8 .
1 9 .
20.
7-26
{
2'1. Use the specialtools to drive a new oil seal
squarely into the block to the specified installed
h e i g h t .
07749-0010000
Measure the distance between the crankshaft (A)
a n d o i l s e a l ( B ) .
Oil Seal Insialled Height:
5.5 6.5 mm
|10.22 0.26 in.l
5.5-6.5 mm
{0.22 0.26 in.l
{
\
07zAo-PNAA100