Cruise Control
1 .
Main Switch Test/Replacement
Remove the driver's dashboard lower cover (see
page 20-59).
Release the clips of the main switch and push the
main switch 1A) out of the panel, then disconnect
the 5P connector (B) from the main switch.
Check for continuity between the terminals in each
switch position according to the table. lf the
continuity is not as specified, replace illumination
bulbs (C) or the switch.
\-------11v1
Position
1
4
OFF
(9
@
ON
o
@
o
\J
o
4-42
r\--
Set/Resume/Cancel Switch Test/
Replacement
1. Remove the two screws. then remove the switch.
Check for continuity between the terminals in each
switch position according to the table.
. lfthere is continuity, and it matches the table, but
switch failure occurred on the cruise control unit
input test, check and repair the switch circult.
. lf there is no continuity in one or both positions,
replace the switch.
\
Terminal
;"itl*
'\
2
sET (ONt
CF
--o
RESUME ION)
o
--o
CANCEL {ON}
o