Honda EP3 Service Manual page 584

30, Retighten the 12 mm flange bolts (A) to the
soecified toroue value.
After tightening the 12 mm flange bolts, install a
new stop plate (B) over one of the bolt heads. Be
sure the tabs (C) of the stop plate are aligned with
the flat surfaces of the bolt head.
Clean off any grease or contamination from the
b o o t i n s t a l l a t i o n g r o o v e s o n t h e h o u s i n g .
Expand the boot (A) by removing the vinyltape,
and fit the boot ends (B) in the installation grooves
o n t h e c y l i n d e r h o u s i n g .
5 t .
3 2 ,
74 N.m (7.5 kgf.m,5ir lbf.ft)
3 4 . C l o s e t h e e a r p o r t i o n ( A ) o f t h e b a n d s ( B ) w i t h
c o m m e r c i a l l v a v a i l a b l e p i n c e r s , O e t i k e r 1 0 9 8 o r
e q u i v a l e n t ( C ) .
3 5 . I n s t a l l t h e n e w l o c k w a s h e r ( A ) w i t h i t s r a d i u s e d
side facing (B) the tie-rod (C), and screw the tie-rod
on the bracket (D). Repeat this step for the other
side of the tie-rod. Hold the bracket with one
wrench, and tighten the tie-rods to the specified
torque with another wrench.
,,";=-.
. . , . ,
(cont'd)
*=,,',
17-61