Lntermediate Shaft Removal - Honda EP3 Service Manual

8. Install a new spindle nut {A), then tighten the nut.
After tightening, use a drift to stake the spindle nut
shoulder {B) against the driveshaft.
{18.5 kgf.m, 134lbt.ft)
9. Clean the mating surfaces ofthe brake disc and the
front wheel, then install the front wheel with the
wheel nuts.
10. Turn the front wheel by hand, and make sure the
clearance between the driveshaft and
circumference parts.
1 l. Refill the transmission with recommended
transmission fluid (see page 13-3).
12. Check the front wheel alignment, and adjust it if
necessary (see page 18-4).
108 N.m
(11.0 kgf.m,
80 tbt.ft)
/
o
o o
e
22x 1.5 mm
1 8 1 N . m
1 .
2 .
lntermediate Shaft Removal
Remove the right driveshaft (see page 16-3).
R e m o v e t h e h e a t s h i e l d .
3 . R e m o v e t h e f l a n g e b o l t { A ) a n d t w o d o w e l b o l t s ( B ) .
€.---2"
E J /
€
w
(cont'd)
1 6 - 1 9