Limit Switch Test; Auto-Stop Switch Test - Honda EP3 Service Manual

l .
2.
Limit Switch Test
Remove the headliner (see page 20-54).
Disconnect the 4P connector from the moonroof
limit switch.
Check for continuily between the terminals in each
switch position according to the table.
NOTE: Turn the motor by hand with the wrench.
\
Terminal
Position
1
3
4
TILT
o- o-
OPEN
CLOSE
lf the continuity is not as specified, replace the
moonroof limit switch.
1 .
2 .
Auto-stop Switch Test
Remove the headliner (see page 20-54).
Disconnect the 2P connector from the moonroof
auto-stop switch.
Check for continuity between the terminals in each
switch position according to the table.
NOTE:
. Turn the motor by hand with the wrench,
. The auto-stop position is about 145 mm (5.75 in.)
from fully closed.
Position
Terminal
1 2
Botwoen AUTO-STOP
and CLOSE
Between OPEN and
AUTO.STOP
lf the continuity is not as specified, repair or replace
the auto-stop switch.
22-113