Sony DMX-R100 Quick Reference page 99

Listening to Prerecorded Surround Material
6
While still viewing the Input/Pan/Assign window, access each of the remaining four channels in turn and
assign them as follows: center signal to MTR bus 3 only at the front center position (upper center from
the dropdown menu); subwoofer signal to MTR bus 4 only at the front center position (upper center
from the dropdown menu); rear left signal to MTR bus 5 only at the rear left position (lower left-hand
corner from the dropdown menu); and rear right signal to MTR bus 6 only at the rear right position
(lower right-hand corner from the dropdown menu).
7
In the Channel window, access each of the six channels in turn and set its fader to the 0.0 dB position for
unity gain. The CR Monitor knob will control the overall level of the entire surround signal (the DIM
and CUT switches in the CR Monitor section work as well) and you can also selectively cut or solo each
of the surround channels by using the corresponding channel cut or solo buttons.
Appendix B Surround Applications
B-5