Procedures; Changing Parameters - Omron SYSDRIVE 3G3MV Setup Manual

Preparing for Operation and Monitoring
n105: Torque compensation core loss
n106: Rated motor slip
n107: Motor phase-to-neutral resistance
n108: Motor leakage inductance
n109: Torque compensation limit
n110: Motor no-load current
n140: Energy-saving control coefficient K2
n158: Motor code

2-2-3 Procedures

Changing Parameters

The setting of n001 is changed so that n176 and n177 can be displayed.
D Setting n01 (Parameter Write-prohibit Selection/Parameter Initialization Parameter)
Key Indicator
---
After about 1 s
Display
(Display after the power supply is turned ON.)
Press the Mode Key until the PRGM indicator lights.
Confirm that n001 is displayed on the data display.
Press the Enter Key.
The setting of the specified parameter number will be
displayed.
Press the Increment Key until 4 is displayed. (The display will
flash.)
Press the Enter Key to confirm the setting. (The display will
stop flashing.)
The display of the parameter number will return in about 1 s.
Chapter 2
Description
2-11