Omron SYSDRIVE 3G3MV Setup Manual page 62

List of Parameters
Param- Regis- Name
eter ter No.
No. (Hex)
n024 0118 Frequency
reference 1
n025 0119 Frequency
reference 2
n026 011A Frequency
reference 3
n027 011B Frequency
reference 4
n028 011C Frequency
reference 5
n029 011D Frequency
reference 6
n030 011E Frequency
reference 7
n031 011F Frequency
reference 8
n032 0120 Inching fre-
quency com-
mand
n033 0121 Upper fre-
quency ref-
erence limit
n034 0122 Lower fre-
quency ref-
erence limit
3-8
Description
Used to set internal frequency ref-
erences.
Note Frequency reference 1 is
enabled in remote mode with enabled in remote mode with
n004 for frequency reference
selection set to 1. selection set to 1.
Note These frequency references
are selected with multi-step are selected with multi-step
speed references (multi-
function input). function input).
Used to set the inching frequency
command.
Note The inching frequency com-
mand is selected with the
inching command (multi-
function input). The inching
frequency command takes
precedence over the multi-
step speed reference.
Used to set the upper and lower
frequency reference limits in per-
centage based on the maximum
frequency as 100%.
Note If n034 is set to a value less
than the minimum output fre- than the minimum output fre-
quency (n016), the Inverter
will have no output when a
frequency reference less
than the minimum output fre-
quency input is input.
Chapter 3
Setting Default Chan-
range setting ges
during
opera-
tion
0.0 to 6.00 Yes
max.
fre-
0.00 Yes
quency
0.00 Yes
0.00 Yes
0.00 Yes
0.00 Yes
0.00 Yes
0.00 Yes
6.00 Yes
0 to 110 100 No
0 to 110 0 No
Memo