Omron SYSDRIVE 3G3MV Setup Manual page 43

Preparing for Operation and Monitoring
Appearance
Note For safety reasons, the reset will not work while a RUN command (forward or reverse) is in effect.
Wait until the RUN command is OFF before resetting the Inverter.
Name
Mode Key
Increment Key
Decrement Key
Enter Key
RUN Key
STOP/RESET Key
Switches the simplified-LED (setting and monitor) item
indicators in sequence.
Parameter setting being made is canceled if this key is
pressed before entering the setting.
Increases multi-function monitor numbers, parameter
numbers, and parameter set values.
Decreases multi-function monitor numbers, parameter
numbers, and parameter set values.
Enters multi-function monitor numbers, parameter
numbers, and internal data values after they are set or
changed.
Starts the Inverter running when the 3G3MV is in operation
with the Digital Operator.
Stops the Inverter unless n007 is not set to disable the
STOP Key. Functions as a Reset Key when an Inverter
error occurs. (See note.)
Chapter 2
Function
2-3