Omron SYSDRIVE 3G3MV Setup Manual page 82

List of Parameters
Param- Reg- Name
eter
ister
No.
No.
(Hex)
n105 0169 Torque
com-
pensation
core loss
n106 016A Rated
motor slip
Note Speed search deceleration time and speed search operating level can be set for 5.5-kW and
7.5-kW Inverters only.
Param- Reg- Name
eter
ister
No.
No.
(Hex)
n107 016B Motor
phase-to-
neutral
resis-
tance
n108 016C Motor
leakage
induc-
tance
n109 016D Torque
com-
pensation
limit
n110 016E Motor no-
load cur-
rent
3-28
Description
Sets the core loss of the motor in use.
Note Normally, the default setting does
not need to be changed.
Note This parameter is enabled in V/f
control mode only.
Used to set the rated slip value of the
motor in use.
Note Used as the constant of the slip
compensation function or vector
control.
Description
Set this parameter to the phase-to-neutral
resistance or 1/2 of the phase-to-phase
resistance of the motor.
Note This parameter is used as a vector
control constant.
Sets the leakage inductance of the motor
in use.
Note This parameter is used as a vector
control constant.
Note The Inverter with the default setting
in this parameter fully functions in
vector control.
Sets a limit on the torque compensation
function in vector control mode.
Note Normally, the default setting does
not need to be changed.
Note The Inverter in torque compensation
control limits the torque at a current
1.5 times larger than the set value.
Used to set the no-load current of the
motor in use based on the rated motor cur-
rent as 100%.
Note Used as the constant of vector con-
trol and the slip compensation func-
tion.
Chapter 3
Set- Default Chan-
ting setting ges
range during
opera-
tion
0.0 to Varies No
6,550 with the
capac-
ity.
0.0 to Varies Yes
20.0 with the
capac-
ity.
Set- Default Chan-
ting setting ges
range during
opera-
tion
0.000 Varies No
to with the
65.50 capac-
ity
0.00 to Varies No
655.0 with the
capac-
ity.
0 to 150 No
250
0 to 99 Varies No
with the
capac-
ity
Memo
Memo