Monitor The Switch; 5320 Series Switch Leds - Extreme Networks ExtremeSwitching 5320 Series Hardware Installation Manual

Monitor the Switch

5320 Series Switch LEDs

The following topics help you monitor the status of the switch while it is operating.
5320 Series Switch LEDs
ExtremeSwitching 5320 Series front panel port LEDs, as described in the following table:
Table 14: 5320 Series Port LEDs
LED
SYStem status LED
(Legacy MGMT function)
PSU status LED PWR
Fan status LED
Bluetooth Status LED (BT) Green Blinking
Speed Mode LED (SPD)
Stack Mode LED (STK)
Locator LED (LOC)
The following figure shows the two alternate mode LEDs for 5320 Series switches: SPD and STK. The
Mode button is used to cycle through three display modes for the port LEDs. In the default mode, SPD
and STK are off. SPD and STK display modes expire after 30 seconds, at which time the port LEDs
revert to the default SYS mode. Pressing and holding the Mode button initiates Bluetooth pairing.
on page 69
Color/State Port State
Green Flash slowly POST Passed,
normal operation, blinks on standalone switch, stack
primary, and backup nodes in a stack;
off for standby nodes in a stack
Green Blinking POST in progress
Amber Blinking POST failed or overheat
Green Power On
Off Power off and no power attached
Amber Blinking Power supply failure
Green Normal operation
Amber Blinking Fan failure
Off Fan or power off
Bluetooth pairing in progress
Green Bluetooth connected
Off Bluetooth not connected
Green Port LEDs indicate rate
Green Port LEDS indicate stack position
Blue Blinking Locator function
ExtremeSwitching 5320 Series Hardware Installation Guide 69