Using The Memory For Copying; Making A Copy While The Machine Is Warming Up (Auto Start) - Canon imageRunner 400 Reference Manual

Using the Memory for Copying

For certain copy functions, the image is first scanned into memory and then used for copying.
Making a Copy while the Machine is Warming Up
While the machine is warming up, an original can be scanned. The message "Ready to scan" is
displayed.
MEMO
Depending on the memory size of the machine, number of originals (LTR size Canon standard chart no.1)
scanned, differs as follows.
memory size
1
Place your originals and select the desired copy mode.
MEMO
When wishing to copy several originals and a special copy mode is not required, use the feeder.
If no copy mode selection has been made, only one original can be scanned from the platen glass.
2
Press the
The message "Scanning ..." appears on the display.
3
After the machine has finished warming up, copying starts.
MEMO
2–28
number of originals
32MB 150 originals
64MB 360 originals
96MB 650 originals
Start
key.
If warmup ends while scanning is still in progress, copying starts at that point.
During scanning, the image quality setting can be changed.
Adjusting exposure during scanning will produce a different result from adjusting exposure
after copying has started.
To cancel copying, press the [CANCEL] key on the touch-panel display or press the
key on the control panel.
When an original has been placed on the platen glass, a display
such as shown at left appears on the touch panel display,
depending on the copy mode.
To scan the next original, press the
When scanning is completed, press the [DONE] key.
(AUTO START)
Start
key again.
Stop