Photo Mode; Storing The Current Standard Settings (Standard Settings) - Canon imageRunner 400 Reference Manual

Photo Mode

This setting gives you the choice of whether or not to use the Photo mode. When the Photo mode is set
to [ON], the [PHOTO] key appears in the Basic Features screen.
MEMO
The initial setting is "OFF."
1 1
Call up the desired screen as follows:
Additional Functions
Key
Storing the Current Standard Settings
"Standard Settings" refers to a combination of copy modes that the machine is set to after the power is
turned ON or when the
Standard Settings can be returned to their initial settings (defaults).
MEMO
The Standard mode initial settings (defaults) are as follows:
Copy quantity
Paper selection
Exposure/Image quality : A
Storing the Standard Settings
MEMO
To change the Standard Settings, copy settings must already have been stored as the Standard Settings.
1 1
Call up the desired screen as follows:
Additional Functions
Key
2
Select the [ON] or [OFF] key, then press the
[OK] key.
3
Reset
key is pressed. This section describes how to store the Standard Settings.
: 1
: Automatic
Custom Copy Settings
Press the [DONE] key.
Repeat this until the Basic Features screen appears again.
(STANDARD SETTINGS)
4–33