Changing The Energy Saver Mode Setting; Setting Inch Input - Canon imageRunner 400 Reference Manual

Changing the Energy Saver Mode Setting

You can change the setting for the Energy Saver mode.
MEMO
The initial setting is "–10%".
1 1
Call up the desired screen as follows:
Additional Functions
Key

Setting Inch Input

When this setting is [ON], keys for inputting values in inches will be displayed on the numeric input screen.
MEMO
The initial setting is "ON".
1
1
Call up the desired screen as follows:
Additional Functions
Key
Custom Settings for Copying, FAX and Printing
2
Select [–10%], [–25%], [–40%] or [RETURN DI-
RECTLY TO STANDARD MODE], and then press
the [OK] key.
MEMO
The approximate energy savings figures for each mode and
the approximate delay times from power ON to ready to
copy are listed below.
• –10% mode
• –25% mode
• –40% mode
• Return Directly to Standard mode
* The figures in parenthesis ( ) show the approximate time it
takes for the machine to return to the ready to copy state.
3
Press the [DONE] key.
Repeat this until the Basic Features screen appears again.
2
Select the [ON] or [OFF] key, then press the
[OK] key.
3
Press the [DONE] key.
Repeat this until the Basic Features screen appears again.
: 19% less power (19 seconds)*
: 30% less power (30 seconds)*
: 43% less power (43 seconds)*
: 2% less power (0 seconds)*
4–15