Mitsubishi Electric FR-A700 Instruction Manual page 136

Simple mode parameter list
Selection method of real sensorless vector control (speed control)
according as required. (Pr. 80, Pr. 81) (Refer to page 5-13.)
Fig. 5-10: Selection of the real sensorless vector control
5 - 16
Perform secure wiring.
(Refer to section 3.2)
Set the motor (Pr. 71). (Refer to page 5-13.)
Set the motor capacity and the number of motor poles
Select a control method. (Refer to page 5-13.)
Set the run command. (Refer to section 5.2).
Set the torque limit. (Pr. 810)
(Refer to section 6.3.2.)
Perform offline auto tuning. (Pr. 96)
(Refer to section 5.1.9.)
Test run
Select online auto tuning as required. (Pr. 95) (Refer to section 5.1.10.)
Select easy gain tuning as required. (Refer to section 5-33.)
Select manual input speed control gain adjustment as required. (Refer to page 5-35.)
Set "3" (standard motor) or "13" (constant-torque motor) in Pr. 71
"Applied motor".
Set the motor capacity (kW) in Pr. 80 "Motor capacity" and set the
number of motor poles (number of poles) in Pr. 81 "Number of motor
poles".
(V/f control is performed when the setting is "9999" (initial value).
Make speed control valid by selecting "10" (speed control) or "12"
(speed-torque switchover) for Pr. 800.
Select the start command and speed command.
1) Start command
– Operation panel: Setting by pressing FWD/REV of the operation
panel
– External command: Setting by forward rotation or reverse rotation
command (terminal STF or STR)
2) Speed command
– Operation panel: Setting by pressing the digital dial of the operation
panel
– External analog command (terminal 2 or 4) :
Give a speed command using the analog signal input to terminal 2
(or terminal 4).
– Multi-speed command:
The external signals (RH, RM, RL) may also be used to give speed
command.
Basic settings