Parameter Copy - Mitsubishi Electric FR-A700 Instruction Manual

Operation panel FR-DU07
4.3.11

Parameter copy

Multiple inverters and parameter settings can be copied.
Connect the operation panel to the copy source
inverter.
Connect it during a stop.
Press the MODE key to choose the parameter
setting mode.
Turn the digital dial until "PCPY" (parameter
copy) appears.
Press the SET key to show the currently set value.
The initial value "0" appears.
Turn the digital dial to change it to the setting
value of "1".
Press the SET key to copy the source parameters
to the operation panel.
Connect the the operation panel to the copy
destination inverter. Check that Pr. 77 of the
destination inverter is not set to disable parameter
writing.
Perform steps
clockwise until "2" appears.
Press the SET key to write the parameters copied
to the operation panel to the destination inverter.
When copy is completed, "2" and "PCPY" flicker.
After writing the parameter values to the copy
destination inverter, always reset the inverter,
e.g. switch power off once, before starting
operation.
Fig. 4-11: Parameter copy
4 - 14
Operation
to again. Turn the digital dial
Display
About 30s later
Flicker ... Parameter copy complete!
About 30s later
Flicker ... Parameter copy complete!
Operation
The parameter number
read previously
appears.
The value flickers
for about 30s.
The value flickers
for about 30s.
I001115E