Parameter Verification - Mitsubishi Electric FR-A700 Instruction Manual

Operation panel FR-DU07
4.3.12

Parameter verification

Whether same parameter values are set in other inverters or not can be checked.
Replace the operation panel on the inverter to be
verified
Replace it during a stop.
Screen at powering on
The monitor display appears.
Press the MODE key to choose the parameter
setting mode.
Turn the digital dial until "PCPY" (parameter
copy) appears.
Press the SET key to show the currently set value.
The initial value "0" appears.
Turn the digital dial to change it to the setting
value of "3" (parameter copy verification mode).
Press the SET key to read the parameter setting of
the verified inverter to the operation panel.
numbers and "rE3" flicker.
If there is no difference, "PCPY" and "3" flicker to
complete verification.
Fig. 4-12: Parameter verification
Possible faults:
● "rE3" appears.
– Set frequencies, etc. may be different. Check set frequencies.
NOTE
When the copy destination inverter is not the FR-A700 series, "model error rE4" is dis-
played.
4 - 16
Operation
If different parameter exist, different parameter
Hold down the SET key to verify.
Operation
Display
The parameter number
read previously
appears.
The value flickers
for about 30s.
Flickering
Flicker ... Parameter verification complete!
I001116E