Prom Programming Tools; Hardware; Software; A.2.1 Hardware - NEC PD78081(A) User Manual

A.2 PROM Programming Tools

A.2.1 Hardware

PG-1500
PROM programmer
PA-78P083CU
PA-78P083GB
PROM programmer
adapter

A.2.2 Software

PG-1500 controller
Remark of the part number differs depending on the host machine and OS used. Refer to the table below.
S PG1500
234
APPENDIX A DEVELOPMENT TOOLS
This is a PROM programmer capable of programming the single-chip microcontroller with on-chip
PROM by manipulating from the stand-alone or host machine through connection of the
separately available programmer adapter and the attached board. It can also program separate
PROM ICs with a capacity from 256 Kbits to 4 Mbits.
This is a PROM programmer adapter for the PD78P083, and is used connected to the PG-1500.
PA-78P083CU: 42-pin plastic shrink DIP (600 mil)
42-pin ceramic shrink DIP (with window) (600 mil)
PA-78P083GB: 44-pin plastic QFP (10
This program controls the PG-1500 from the host machine through serial and/or parallel interface
cable(s).
Part Number: S PG1500
Host Machine
5A13 PC-9800 Series
5A10
7B13 IBM PC/AT and their
7B10 compatible machines
Note The task swap function is not available with this software through the function is
provided in MS-DOS version 5.0 or later.
10 mm)
OS
MS-DOS
Note
(Ver. 3.30 to 6.2 )
Refer to A.4
Medium
3.5-inch 2HD
5-inch 2HD
3.5-inch 2HC
5-inch 2HC