Automatic Voice Vlan Id Configuration - Nortel IP Phone 2002 User Manual

Standard
Table 17 Configuration parameters
Parameter
Speed
Duplex
Cfg XAS
Voice VLAN
PCUntagAll
After pressing the Ok soft key on the last configuration parameter, you see a
message "Locating Server".

Automatic VOICE VLAN ID configuration

As part of the 802.1Q feature, there is an option to automatically discover the
VOICE VLAN ID using DHCP. This process reduces the configuration steps
since entering the data manually (the VOICE VLAN ID) is not required.
The IP Phone is configured when the Automatic VOICE VLAN Discovery using
DHCP approach. The following steps are automatically taken to obtain the
VOICE VLAN ID.
Value
0-A, 1-10, 2-100
0-A, 1-F, 2-H
0-No, 1-Yes
0-No, 1-Yes
0-No, 1-Yes
Definition
Default 0 (for Auto).
0 = Auto
1 = 10 BT
2 = 100 BT
Note: You are not prompted
for Speed if PC Port is set to
0 for Off.
Default 1(for Auto).
0 = Auto
1 = Full
2 = Half
Note: You are not prompted
for Duplex if PC Port is set to
0 for Off and if Speed is set
to 0 for Auto.
Default 0 (for No)
Default 0 (for No)
Note: You are not prompted
for Voice VLAN if 802.1Q is
not enabled.
Default 0 (for No)
IP Phone 2002 User Guide
111